产品简介

Bantape® 3025 R/CW 标称 30 微米（1.2 mil）高拉伸强度铝箔背衬，与寒冷天气阻燃丙烯酸粘合剂相结合，由易释放的硅胶离型纸保护。

可操作的箔片可轻松适用于纤维和钣金管道，并适用于不规则的表面。Bantape® 3025 R/CW 擅长于苛刻的温度和湿度应用，并在各种环境条件下提供卓越的性能和耐用性。

典型应用

HVAC 行业用于连接和密封箔-涂鸦-卡夫面对层压玻璃纤维毯/管道板接缝和接缝; 连接和密封柔性气管接缝和连接. 通用的固定、修补、密封和遮蔽应用-室内和室外。

产品使用用

户必须评估 Bantape® 3025 R/CW 产品，以确定它是否适合特定用途和用户的应用方法。 当在干净、干燥的表面上施加适当的压力在 +10 〜 +40°C（+50 〜 +105 °F）之间时，将获得良好的效果。

表面处理

与所有压敏胶带一样，必须使用胶带的表面清洁、干燥，不含油脂、油脂或其他污染物。

在 21°C (70°F)/50% 相对湿度避免阳光直射的情况下保存，可保存 12 个月。

英文介绍

Bantape®3025 R/CW nominal 30 micron (1.2 mil) high tensile strength aluminum foil backing, combined with a cold weather flame retardant acrylic adhesive, protected by an easy-release silicone release paper.
The workable foil applies easily to both fibrous and sheet metal ducts and conforms to irregular surfaces.Bantape® 3025 R/CW excels in demanding temperature and humidity applications and provides superior performance and durability over a wide range of environmental conditions.

TYPICAL APPLICATIONS

HVAC industry for joining and sealing Foil-Scrim-Kraft Facing laminated fiberglass blanket / duct board joints and seams; joining and sealing flexible air duct seams and connections. General purpose holding, patching, sealing and masking applications – indoors and outdoors.

PRODUCT USE

It is essential that the user evaluate the Bantape®3025 R/CW product to determine whether it is fit for a particular purpose and user’s method of application. Good results will be obtained when applied to a clean, dry surface with a suitable pressure on Bantape® 3025 R/CW products between +10 ~ +40°C (+50 ~ +105 °F).

Surface Preparation

It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied must be clean, dry, free of grease, oil or other contaminants.

Storage & Self Life

12 months when stored at 21°C (70°F) / 50% relative humidity out of direct sunlight.